This equipment is widely used for the manufacture of ventilation components, drainage equipment, in cases of production of cylindrical and conical products, straightening of flat workpieces, hemming of edges.

Peculiarities:

1. Roller with three asymmetrical shafts
2. Rollers are made of high-strength steel
3. Grooves for bending rods
4. Top roll swing-out mechanism with eccentric clamp
5. Possibility of bending to a cone
6. Remote pedal with emergency stop button
7. The upper roller rotates in both directions

*Maximum permissible sheet thickness when working with low-carbon steel (yield strength σs should not exceed parameter σs ≤245 MPa) – no more than 1.5 mm

*The minimum diameter of the resulting workpiece when working with 1.5 mm low-carbon steel will be at least 100 mm (this information is for reference and depends on the grade, heat treatment strength of the material, as well as its length and thickness).

Specifikation:

When working with metal thickness (stainless steel) ≤ 1.0 mm – maximum possible min. The Ø of the shell can be 110 mm (this information is for reference and depends on the type, strength, heat treatment of the material, as well as its length and thickness).

There is no exact formula for calculating the minimum diameter of the resulting workpiece, because it depends on the type, grade, heat treatment of the material, as well as its length and thickness. A more accurate determination of the minimum Ø is possible only by test rolling.